Outline your print. Consider something fascinating and attract it on to a bit of paper. Don't stress over shading or shading it - you'll be removing it and utilizing whatever is left of it as a stencil.
Keep it basic right away. Geometrical shapes and rounds in an uneven example are least demanding and never buzzword. Space them far enough separated in case you're a fledgling - you don't need the paper to tear while being cut.
Utilize an art blade to remove all the shaded parts of your configuration. Keep the encompassing clear paper in place. You have now made your stencil. Lamentably, in the event that it tears, you'll presumably need to begin once again. Activity consideration and exactness.
Make beyond any doubt your stencil fits suitably on your shirt. In the event that it doesn't, you'll need to re size or overall conform it.
Put your stencil on top of your material (paper or shirt) and the screen on top of the stencil. Place the stencil so the cross section is specifically on top (the two ought to be touching) and the handles are confronting up. In the event that there is space between the edges of your stencil and the edges of your screen, put concealing tape on the underside. You don't need paint spilling where it shouldn't spill.
If you utilize the taping strategy, make a point not to tape the stencil to the lattice! Overall the stencil may move around when you're squeegee-ing it.
Spoon out some paint. Make a line at the highest point of the screen (the part uttermost far from you). You don't need paint on top of the stencil right now. Attempt to spoon out as much paint as you think would cover the stencil.
It's a bit hard to utilize more than one shade with this system. On the off chance that you do attempt it, realize that sooner or later or other, the shades will blend. In case you're alright with that, put it all on the line!
Utilize the squeegee to spread the paint over the cross section. Attempt to do it with one downwards development - or the minimum number of strokes conceivable. This makes it look as smooth and expert as anyone might imagine.
Always, dependably, dependably, make vertical strokes. On the off chance that you make both flat and vertical strokes, the paint will bunch and be harder to dry and completion.
Once you achieve the base, continue going and scoop the abundance paint up the handle to be reused.
Lift everything up off your material. Be watchful! On the off chance that you drag it whatsoever, the paint may spread. It's best to do it layer by layer, lifting up and after that off.
Leave to dry. The more extended, the better.
if you printed onto attire, then once it is dry you have to put a sheet of lubing or following paper over your outline and iron it. This seals it, making it wearable and launder able.
Tips
- If the edges of your stencil are all harsh or you continue tearing it, you are most likely not holding the art cut effectively. Conform the position of your hand.
- Spread the paint in stand out bearing! Alternately else the paint will glob up and be more hard to dry.
- If you are printing onto a shirt, put a layer of daily paper inside on the grounds that the paint may leak through and stain the other side.
- You can search through magazines for plans as opposed to drawing your own. Alternately print off a photograph and remove parts of that.
Warnings
- Paint will stain; wear old garments.
- Use a cutting tangle so you don't scratch the table.
- Craft blades are sharp - be watchful. Continuously set away or spread the cut
No comments:
Post a Comment